Redundant Power Supply DPS-200A
Keeps your switch online in case of power supply failure.
- Provides backup power for switch’s built-in power supply
- Over-current protection
- Flexible Deployment Options
- Can be installed as stand-alone power supply units or mounted in a 19-inch multi-slot chassis
- Hot-swappable when installed in a chassis
- Solid metal case housing
Guaranteed Power Protection
The DPS-200A, DPS-500A and DPS-500DC redundant power supplies (RPS) are designed to conform to the wattage requirements of D-Link’s Ethernet and Gigabit switches. They are external RPS units enclosed in solid metal cases with sockets to AC or DC power sources on one end and connect to a switch’s internal power supply on the other end. They provide a low-cost, simple solution to the problem of an inadvertent failure of the internal power-supply of an Ethernet switch, which can result in the shutdown of that switch, the devices attached to its ports, or an entire network. Supporting full output power for the switch, these redundant power supplies can maximize the power availability of the switching device.
Easy and Flexible Deployment
Deployment of a DPS series device does not require any change in the configuration of the LAN switch. Each RPS is equipped with an universal internal power supply and can be connected to any AC power source from 90 V AC to 264 V AC, 47 Hz to 63 Hz through a standard AC power cable.
Integrated Detection Circuit
Each D-Link RPS is equipped with an integrated detection circuit that continuously monitors the switch’s internal power supply. In the event of a power interruption, the redundant power supply is immediately triggered so that the LAN switch and its connected devices can continue providing service. This results in a more reliable network infrastructure and protects the network from going down due to failure of a single network device power supply.
|172 x 257 x 43 mm ;Panel size: 196 x 52 mm
|Input Voltage Range
|90 to 264 VA
|47 to 63 Hz
|Max Input Current
|2 A @ 100 VAC • 1 A @ 240 VAC
|Max Inrush Current
|• 30 A @ 115 VAC • 60 A @ 230 VAC
|0 to 50 °C
|from -40 to 85˚ C
|10 to 90% RH
|10 to 95% RH
|60 Watt Redundant Power Supply